Removal and Replacement

Removing And Installing Steering Knuckle







CAUTION:
- To remove the steering knuckle the shock absorber must be installed
- Installation: Replace self-locking nuts and bolts

1 Remove front wheel
2 Remove brake disc
3 Remove front wheel hub (9)
4 Remove brake splash shield (35)
5 Remove Vss sensor (L6/1) and brake pad wear indicator
6 Remove tie rod (10) from steering knuckle
7 Remove supporting joint (7) from steering knuckle (5)
8 Remove steering knuckle (5) from upper wish bone (6)
9 Check supporting joint
10 Measure steering knuckle, if necessary
11 Install in reverse order
12 Perform chassis alignment check

NOTE: After installation of new parts