Removal and Replacement

91-155 Removing And Installing Control Cables For Backrest Lock










Removal, installation







Cable control for inside backrest lock
1 Unscrew handle recess and remove.







2 Loosen clamping nut and screw off nut for pull sleeve (arrows).
3 Remove control cable and pull sleeve on release handle.







4 Open cable straps and expose control cable.







5 Unhook control cable on backrest lock while observing bellows and completely remove pull cable.
6 Install control cable and adjust to play of 0 - 1 mm.
7 Reinstall in opposite order.







Control cable for outside backrest lock
1 Remove side covering on backrest frame (91-060).
2 Loosen clamping nut on release handle and screw nut off of pull sleeve (arrows).
3 Unhook control cable and pull sleeve on release handle.







4 Remove retaining ring on inside of bolt for backrest hinge.







5 Carefully knock out bolt with 17 mm dia. plastic punch; unlock backrest for this purpose. Do not damage plastic bushing during installation (arrow).







6 Pull locking mechanism downward slightly and unhook control cable.
7 Unhook pull sleeve while paying attention to bellows and pull upward and out.
8 Install control cable and adjust to play of 0-1 mm.
9 Reinstall in opposite order.