Replace Front Shock

Models With Adaptive Damping System (ADS)





Front Adaptive Damping System (ADS) Exploded View






Image Legend


REMOVAL

NOTE: The vehicle must be on its wheels for removing the upper shock absorber attachment.

1. Detach upper shock absorber attachment with anti-twist lock
- Steady at piston rod

NOTE:
^ Turn shock absorber for Adaptive Damping System (ADS) so that the damper valve paints outwards.
^ The damper valve must NOT contact the spring dome.
^ Observe removal and installation position or shock absorber/ADS

2. Lift vehicle
3. Disconnect electrical cable at valve connector
- Pay attention to correct routing of electrical cable.
4. Detach shock absorber/ADS at wishbone.
- Insert shock absorber/ADS in the hole in the front end and remove between the upper wishbone and steering knuckle and spring dome
5. Check shock absorber, rubber gaiter and shock absorber mount or rubber mount for damage and cracks.

INSTALLATION
Install in reverse sequence, noting the following:
- Replace self locking nuts when installing
- Ensure adequate clearance between the damper valve and upper wishbone.
- Place the shock absorber in the installed position; the damper valve must point towards the spring dome.
- Install clip on the damper valve and clip on electrical cable
- Tighten the following components as noted:
- Self-locking nut of shock absorber/ADS on front end: 35 Nm
- Self-locking nut of shock absorber/ADS on wishbone: 55 Nm