In Rear Bumper

Removing and installing Parktronic System (PTS) sensors in rear bumper

Model 208:

Model 210:

1 Remove rear bumper
2.1 Disconnect rear bumper Parktronic system (PTS) connector (X35/28) in trunk on right side

NOTE: Pull lead with grommet out of trunk to side.

2.2 Disconnect rear bumper Parktronic system (PTS) connector (X35/28) in trunk on left side

NOTE: Pull lead with grommet downward out of trunk.

3 Unclip damping elements (4)
4 Unclip Parktronic System sensor (1) from bracket

See "Special Tools" given below.

5 Disconnect connector (3) from sensor (1)
6 Remove seal (2) from sensor (1)
7 Install in the reverse order

Special Tools

In Rear Bumper

Model 208:

Model 210:

Releasing Tool, P/N # 140 589 06 31 00: