B. Mounting the Telephone Linear Compensator (Pse)

B. Mounting the Telephone Linear Compensator/Portable Support Electronics Module (PSE)

1. Remove the left trunk liner-panel.

2. Locate the:

^ 25-pole D-connector

^ coaxial cable from the center console

^ fiber optic cables

^ integrated antenna cable (passes through the fender grommet)

^ 15-pole D-connector (if installing the Voice Recognition System)

Figure 1:

3. Mount the PSE module to the mounting plate with three (3) M4 x 6 machine screws. The 25-pole connector should face right and the fiber optic connector on top when installed (Figure 1).

4. Mount the linear compensator to the mounting plate with three (3) M4 x B machine screws. The green 14-pole connector should be on the same side as the 25-pole PSE connector (Figure 1).

5. Connect the 25-pole PSE D-connector labeled PSE to the PSE module and the green 14-pole connector to the linear compensator. (Fold the excess cable between the PSE module and linear compensator and use 2 wire ties to secure them to the larger cable (Figure 1).

Note: Be sure no stress is placed on the wires leading to the linear compensator.

6. Proceed to:

^ Section C if installing the optional Voice Recognition System

^ Section D if NOT installing the optional Voice Recognition System