AR67.30-P-4010K Remove/Install Rear Side Window Molding

AR67.30-P-4010K Remove/Install Rear Side Window Molding







Removal
1 Open front door

CAUTION: Damage hazard Avoid damaging paint, do not use metal tools with sharp edges

2 Slide cover (2) forwards until separation joint is free

See "Special Tools" given below.

3 Press molding (1) off of clips (4) with installation wedge (arrow)

See "Special Tools" given below.

4 Remove molding (1)

Installation
5 Check clips (4, 6 each)
6 Position molding (1) with rubber gasket on clips (4), align and press on
7 Slide cover (2) over separation joint
8 Check position of gasket on molding (1) correct if necessary
9 Close front door


Special Tools

Installation Wedge, P/N # 110 589 03 59 00: