Removal and Replacement

Rear Suspension-control Module, Removal And Installation

Illustrated Using Model 203.2:

DANGER:
- Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure Risk of poisoning from swallowing hydraulic fluid
- Render the hydraulic system pressureless before commencing work on system Wear protective clothing and eye protection

1 Drain hydraulic system

NOTE: Installation: Recharge hydraulic system

CAUTION: General notes for working on vehicles with level control / ADS

2 Disconnect high-pressure supply lines (S1, P) from suspension-control module (3)
3 Disconnect return line (T) from suspension-control module (3)
4 Detach linkage rod for suspension-control module (7) from torsion bar
5 Remove suspension-control module

NOTE: Installation: Replace self-locking bolts

6 Transfer linkage rod for suspension-control module (7)
7 Reverse the removal sequence to install
8 Check and adjust reference point for self-leveling suspension
9 Check and correct headlamp adjustment