Remove/Install Electronic Ignition/Starter Switch (Eis/Ezs)

Removal And Installation Of Electronic Ignition/starter Switch (EZS)













1 Remove cover below instrument panel
2 Unscrew screw from bottom right of instrument panel
3 Unscrew escutcheon (36a) from instrument panel using a claw-type wrench (020) m
4 Remove electronic ignition/starter switch (N73)

NOTE: Installation: Shift lock (36h) points to the top left

5 Remove shift lock (36h), by compressing the retaining clips (arrows) and moving the shift lock forwards out of the retaining lugs
6 Disconnect electrical connectors
7 Install in reverse order