Preparation For Test - Section 22

Preliminary work:
Diagnosis - Diagnostic Trouble Code (DTC) Memory. Section 12. Diagnostic Trouble Code (DTC) Memory (CF) - Section 12

Preparation for Test
1. Battery voltage > 11 V,
2. Fuses ok,
3. Disconnect battery ground cable prior to connecting or disconnecting any electrical connector to any control module (to prevent the storing of erroneous diagnostic trouble codes),
4. HHT Module: "Component Connections"
5. Voltage supply to all the following control modules:
- Circuit 15R from electronic ignition switch control module (N73)
- Electronic ignition switch control module (N73)
- Lower control field control module (N72)
- Front driver-side door control module (N69/1)
- Front passenger-side door control module (N69/2)
- Rear driver-side door control module (N69/3)
- Rear passenger-side door control module (N69/4) and
6. All CAN data lines ok, see CAN. Testing and Inspection
7. Model 208.4 only:
Switch middle console (S21/1) is installed instead of switch N72s1.
821/1 is connected to the Roll bar/power soft top control module (N52).

See electrical wiring diagrams


NOTES:
Observe version coding for:
Front driver-side door control module (N69/1)
Front passenger-side door control module (N69/2)
Electronic ignition switch control module (N73)

For test measuring purposes, the CAN connection to the following control
modules must be connected:
PSE control module (A37)
Signal pickup-and activation module (SAM) (N10/1)

Model 208
Synchronization of the windows is only possible with the doors closed.

Special Tool:

Conventional tools, test equipment
Description Brand, model, etc.
Multimeter 1) Fluke models 23, 83, 85, 87

1) Available through the MBNA Standard Equipment Program.