AR26.50-D-2002-01B Remove/Install Reverse Idler Shaft With Reverse Gear

AR26.50-D-2002-01B Remove/install reverse idler shaft with reverse gear
- Transmission 716.601 [model 203.04]
- Transmission 716.622 [model 170.44]


Gear set, shafts

Gear set, shafts:

Component Identification:

Removing
1 Remove bolt (1) from bearing shell (6).
2 Heat rear section of transmission housing on outside at bearing shell (6) using hot air gun.
3 Remove bearing shell (6).
4 Remove reverse idler shaft (2), cylindrical roller bearing (3), reverse gear (4) and washer (5).

Component Identification:

Install
The cylindrical roller bearing (3), reverse idler shaft (2) and washer (5) must be oiled.

5 Place cylindrical roller bearing (3), reverse gear (4) and shim (5) on the reverse idler shaft (2).

Note the position of the threaded hole on the reverse idler shaft (2) (arrow).

6 Install bearing shell (6) together with reverse idler shaft (2) and reverse gear (4).
7 Adjust bearing shell (6) with bolt (1).
8 Use plastic mallet to drive in reverse idler shaft (2).
9 Adjust reverse idler shaft (2) and secure with bolt (1).