AR27.60-P-0900B Remove/Install Floor Shift

Remove/install floor selector







Remove/install

1 Remove shift rod at intermediate lever (97)

NOTE: Remove clip retainer.
- If adjusting: Adjust shift rod.

2 Remove center console
3 Remove insulation mat
- Model 163

4 Unscrew hexagon socket bolts (40)
5 Disconnect couplings

NOTE: From gear identification switch (S16/10), reverse lamp switch (S16/10s2) and R/P lock electromagnetic actuator (Y66/1).

6 Remove floor selector

NOTE:
- Disassemble and assemble floor shift according to condition.
- Installation: Check gasket (39) for correct installed position and condition, replace if necessary.

7 Install in the reverse order

NOTE: After installing the floor shift, read out fault code using HHT and erase, refer to DM Chassis Volume 1 - Index 0.