Procedure

Figure 1:

1. Remove cover and unlock the locking clip of the previous cover with a screwdriver (arrow, Figure 1) and remove it from the panel.

Figure 2:

2. Take connector out of the removed cover and reinstall it in the modified cover (Figure 2).

Note: The bore in the connector must face the peg in the inside of the cover (arrow, Figure 2).

Figure 3:

3. Insert cover in the B pillar panel.

Note: Locking clip must be in unlocked position (arrow B, Figure 3).

Figure 4:

4. Use a screwdriver (3 mm) to push the locking clip upwards through the oblong hole in the flap of the cover and lock it (arrow, Figure 4).

Figure 5:

5. Check cover and flap for correct fit. Be sure flap moves easily (Figure 5).