Rear

Fig. 4 Rear Wheel Speed Sensor:

REMOVAL
1. Remove rear seat or rear storage compartment.
2. With ignition switched off, loosen cable on cable connector and also loosen clamps attached to the rpm sensor cable.
3. Pull cable in downward direction through rubber grommets in frame floor and axle carrier.
4. Loosen hex. socket screw and remove rpm sensor from rear axle housing.

INSTALLATION
1. Replace O-ring on rpm sensor.
2. Insert rpm sensor into rear axle housing, making sure that the O-ring is not damaged and that the rpm sensor rests with its flange against rear axle housing.
3. Attach rpm sensor with hex. socket screw to rear axle housing. Refer to "SPECIFICATIONS" for tightening torque.
4. Pull cable in upward direction through rubber grommets in axle carrier and frame floor and connect to cable connector.
5. Attach cable with clamps
6. Install rear seat or rear storage compartment.
7. Complete tests.