Ignition Switch Lock Cylinder: Service and Repair

Removal of Lock Cylinder:





- On model 124, remove cover (37l) from the instrument panel.
- On model 201, remove escutcheon (36a) using a small screwdriver.
- On model(s) 124 or 201, turn lock cylinder (36) into position "1" with key.
- Press disengaging wire (0100) into the bores (arrows) and unlock the locking detents by overcoming the spring resistance.
- Remove lock cylinder (36) with cap (36b) from steering lock (37).
- Remove key and disengaging wire (0100) from lock cylinder (36), remove cap (36b).

Installation of Lock Cylinder:
- Install lock cylinder (36) in the cap (36b), push in key and turn into position "1". Press lock cylinder (36) into the steering lock with key and cap (36b) until the cap (36b) engages (observe groove assignment).

NOTE: If the lock cylinder/key is notchy or binding, spray lock cylinder with lock cylinder grease. If the complaint cannot be eliminated, replace lock cylinder and the key which has been in continual use.

Lubricants:
Lock cylinder grease Part no. 001 989265110

Shop Made Tool (0100):

Shop-Made Tool:

Effective length of wire = 320 mm.