Models 124, 126 and 201 W/ Engines 601, 602 or 603
ProcedureMODELS 124,126 AND 201 WITH ENGINES 601, 602 OR 603
1. Remove/install poly-V-belt, fan and fan shroud (SMS, Repair Instructions, Job no. 13-342).
2. Remove/install lower front engine encapsulation panel (SMS, Repair Instructions, Job no. 13-342).
3. Remove/install crankshaft pulley and vibration damper.
Tightening torque:
Hex socket screws 25 Nm
4. Apply sealant/locker to the fitting (arrow, Figure 1) and tap it into the lower vent bore of the coolant pump with a suitable mandrel.
5. Push the drainage pipe (1, Figure 2) over the fitting with a drift (2).
6. Push the drainage pipe (1, Figure 3) behind the oil dipstick tube (2).
Turn the lower end of the drainage pipe toward the ribs of the generator bracket (3) so coolant exiting from the vent bore will run into the passages.
Parts Information
Part Name Part Number
Drainage pipe kit 60320017 52
Sealant/locker (e.g. Loctite(R) 242/Wurth(R) 242) Local purchase
In Case of Warranty
Operation: Coolant pump drainage pipe, retrofit (02-2028)
Coolant pump drainage pipe, install (02-2029) (when replacing coolant pump)