Sensors and Switches - Powertrain Management: Technical Service Bulletins

• Customer Interest
  • Idle Speed - Installing Harness and Resistor
• By Symptom
  • Customer Interest
    • Idle Speed - Installing Harness and Resistor
  • Driveability
    • Engine Cuts-Out, Cannot Be Restarted
    • On-Off Ratio Won't Adjust After Repair, MIL on
    • Engine Surges at Idle at Operating Temp.
  • Out of specification
    • MIL ON ON/OFF Ratio Unadjustable After Repair Work
  • Poor performance
    • Idle Speed - Installing Harness and Resistor
  • Starting problems
    • Engine Cuts-Out, Cannot Be Restarted
    • Engine is Difficult to Start, Cold or Warm
    • Engine Does Not Start
    • Engine - Difficult to Start Cold and Warm
  • Vibration
    • Idle Speed - Installing Harness and Resistor
• All Technical Service Bulletins
  • Electrical - Electrostatic Discharge Damage Prevention
  • MIL ON ON/OFF Ratio Unadjustable After Repair Work
  • O2 Sensors - Avoiding Bogus Test Results
  • Engine Cuts-Out, Cannot Be Restarted
  • On-Off Ratio Won't Adjust After Repair, MIL on
  • Engine is Difficult to Start, Cold or Warm
  • Engine Does Not Start
  • Engine - Difficult to Start Cold and Warm
  • Engine Surges in Idle at Operating Temperature
  • Idle Speed - Installing Harness and Resistor
  • Deceleration Delay When Lifting Foot From Accelerator
  • No Speed Signal Momentarily
  • Engine Surges at Idle at Operating Temp.