Body - Automatic Liftgate Reverses Direction When Closing

Liftgate reverses direction at the bottom when closing

Topic number LI72.20-P-053761

Version 1

Design group 72.20 Rear door, tailgate

Date 06-07-2012

Validity MODEL 251 from VIN end number A123392 to A145873

Reason for change Validity adapted

Complaint:
The automatic liftgate reverses direction at the lower end position when being closed.

Cause:
During the closing sequence the liftgate collides with the obstruction sensor strip, which triggers the anti-pinch protection function.

Remedy:
Adjust the liftgate by adjusting the striker.

The gap between the liftgate and the side wall should measure approx. 6.5 mm (see Figure 1).

Note:
It must be ensured that when the liftgate is closed there is a gap between the liftgate and the obstruction sensor strip along its entire length. This can be verified if it is possible to slide a piece of paper along the gap with no resistance.





Attachments





Symptoms





Figure 1