AN82.70-P-0008-01GQ Retrofit Comfort Telephony Wiring Harness

AN82.70-P-0008-01GQ Retrofit Comfort Telephony Wiring Harness
Model 166.0
- with code (512) COMAND APS with DVD changer
- with code (523) MB Audio 20 radio
- with code (527) COMAND APS with single DVD drive (with navigation)
- except code (494) USA version





1 Route wiring harness for comfort telephony (1) from installation position of Bluetooth(R) module (A34/7) to the C- pillar at the left in the cable duct and along the existing wiring harnesses.
Perform operation steps 2 and 3 only with code (228) Stationary heater.
2 Install mobile phone antenna splitter and stationary heater radio remote control (A2/53) on C-pillar at left.
3 Connect electrical connectors (2) to mobile phone antenna splitter and stationary heater radio remote control (A2/53).
4 Connect electrical connectors to mobile phone antenna amplifier / compensator (A28/3).
5 Fasten comfort telephony wiring harness (1) with cable tie.
6 Route wiring harness for comfort telephony (1) from C-pillar at left along existing wiring harnesses to multifunction antenna (A28/11).
7 Connect electrical connector (3) to multifunction antenna (A28/11).
8 Fasten comfort telephony wiring harness (1) with cable tie.