E1992

No CAN message was received from control unit N82/1 (Vehicle power supply control module).


Possible cause:

- Fault in CAN communication with control unit N82/1 (Vehicle power supply control module).
- Drive train CAN bus
Affected functions:

- CAN Communication
- Drive position selection

-------------------------------------------------

Test 1: Check the CAN communication with control unit N82/1 (Vehicle power supply control module).

Test 2: Drive train CAN test

Test 3: Chassis CAN test

1. Check the CAN communication with control unit N82/1 (Vehicle power supply control module).
Warning!Communication with ECU required.


2. Drive train CAN test
Warning!Communication with ECU required.

3. Chassis CAN test
Warning!Communication with ECU required.