E1977

No CAN message was received from control unit N80 (Steering column module). Current symptom : The selector lever cannot be moved into position "P".

Test 1: Drive train CAN test

Test 2: Chassis CAN test

Test 3: Possible cause:

- Drive train CAN bus
Affected functions:

- Drive position selection

Test 4: Check the CAN communication with control unit N80 (Steering column module).

1. Drive train CAN test
Warning!Communication with ECU required.

2. Chassis CAN test
Warning!Communication with ECU required.

3. No further information available.


4. Check the CAN communication with control unit N80 (Steering column module).
Warning!Communication with ECU required.