AH54.00-N-1000-05A Notes on Handling Battery When Working on Vehicle Electrical System

AH54.00-N-1000-05A Notes On Handling Battery When Working On Vehicle Electrical System

Model XD1, XD2, XD3, XD4, XD5, XD6, XD7, YD1, YD2, YD3, YD4, YD5, YD6, YD7, WD1, WD2, WD3, WD6, WD7







- The information plate (1) relating to work in the seat box is relevant only for the layman.
The guidelines listed below apply to the workshop specialist.

- In general the following should be observed for work on the electrical system:
The battery is disconnected for:
- welding
- Work which goes into the on-board electrical system in greater depth (e.g. retrofitting components or working on individual live cables which are not insulated)
- Work on the starter and alternator (if live cables are disconnected and connected)
- Removal and installation of transmission (starter hangs loose in mounting)
- Work on airbag units and emergency tensioning retractor units, on the airbag control unit and the Lateral acceleration sensors (windowbag)
- Removal of seat frame for driver seat