AZ54.61-D-0002-03A Connect Tachograph Retroactively and Install

AZ54.61-D-0002-03A Connect Tachograph Retroactively And Install







1 Screw the rubber guide plug (1) onto the grub screw on the back of the tachograph (A56).







2 Insert installation frame (4) for the tachograph into the installation opening below the control and operating unit for climate control.
3 Connect sensor adapter line (2) and tachograph wiring harness (3) to the tachograph.







4 Position the tachograph (A56, ) at the installation opening and press in until it latches noticeably in the installation frame
5 Bind sensor adapter line and branch-off lines of tachograph wiring harness under the instrument panel to existing lines and wiring harnesses.
If there is an excessive length, strap down lines at a suitable point. Pay attention to stress-free and chafe-free line routing, attach chafe protection if necessary.