GF54.61-D-0002-03H Modular Tachograph (MTCO), Operating Notes

GF54.61-D-0002-03H Modular Tachograph (MTCO), Operating Notes
- with CODE (J19) Automatic 1 day/2 driver tachograph (EC)







Menu sequence, adjusting the time
31 Display
32d Menu button

The procedure for the function "adjusting time" is described in the following. The following function requirements must be met:
- Vehicle is stationary
- Circuit 15 ON
- No tachograph disk(s) inserted in tachograph (A56)

Briefly pressing the Menu button on the tachograph changes the tachograph display from the basic display to the "Set time" display.
Longer actuation of the Menu button changes the tachograph display back to the basic display.







Final display "adjust the time"
31 Display
31b time display
31i Plus button display
31j Minus button display

By briefly pressing the Menu button on the tachograph, it is possible to jump to the initial "Set time" display on the tachograph display.







Minute counter activated
31 Display
31b time display
31i Plus button display
31j Minus button display

Pressing the Plus button and Minus button simultaneously on the tachograph activates the minute counter in the time display on the tachograph (the minutes flash).







Minute counter activated and counted up
31 Display
31b time display
31i Plus button display
31j Minus button display

Pressing and holding down the Plus button on the tachograph increases the minutes. Pressing and holding down the Minus button on the tachograph decreases the minutes. Releasing the respective button sets the minutes in the time display on the tachograph.







Hour counter activated
31 Display
31b time display
31i Plus button display
31j Minus button display

Briefly pressing the Menu button on the tachograph activates the hour counter on the tachograph display (the hours flash).







Hour counter activated and counted down
31 Display
31a Date display
31b time display
31i Plus button display
31j Minus button display

Pressing and holding down the Plus button on the tachograph increases the hours. Pressing and holding down the Minus button on the tachograph decreases the hours. Releasing the respective button sets the hours in the time display on the tachograph.

The date on the tachograph display is changed automatically as the time setting passes through 00:00 (midnight).







Basic display
31 Display
31a Date display
31b time display
31c Time display group symbol, driver 1
31e Display of total kilometer reading
31h time display group symbol, driver 2

Long actuation of the Menu button on the tachograph stores the selected time. The basic display appears on the tachograph at the same time.







Fault display, tachograph disks inserted
31 Display
31b time display
31c Time display group symbol, driver 1
31d Display of tachograph disk symbol, driver 1
31f Fault symbol display
31g Display of tachograph disk symbol, driver 2
31h time display group symbol, driver 2

If the time is set with the tachograph disk(s) inserted, the symbol for "Tachograph disk driver 1" and the symbol for "Tachograph disk driver 2" as well as the fault symbol will be shown on the tachograph display and the colon in the time display will flash after the time is stored. The time is adjusted and stored only after the tachograph disk(s) is/are removed.