GF40.15-D-0001-02HL Tire Pressure Monitor (RDK) Activation

GF40.15-D-0001-02HL Tire Pressure Monitor (RDK) Activation





1 "M" button
A1s3 Plus button
A1s4 Minus button

In the event of air pressure changes by the driver, in the event of a wheel replacement or a tire change, new air pressure values in the TPM [RDK] control unit (N88/1) are detected automatically by filling detection. The manual reactivation is only intended as a stopgap solution, when the automatic filling detection fails (except code (ZU7) Canada national version, except code (ZU8) USA national version, except code (ZU9) Mexico national version).

Always conduct manual reactivation for vehicles with code (ZU7) Canada national version, code (ZU8) USA national version or code (ZU9) Mexico national version for air pressure changes by the driver, for a wheel change or tire replacement.

Sequence of tire pressure monitoring (TPM) activation

The following procedure must be followed for activation:
^ Correct air pressure at each wheel.
^ Switch on ignition ("circuit 15 ON").
^ Press the "M" button on the instrument cluster (A1) until "+CAL- TPMS" appears on the display (A1p1).
^ Pressing the Plus button causes the message "OK TPMS" to appear on the display. Activation has been started.