GF54.30-D-0002-05HL Instrument Cluster (IC), Operating Information
GF54.30-D-0002-05HL Instrument Cluster (IC), Operating Information
- except CODE (JK3) High-end instrument cluster with speedometer in km
Schematic representation
1 M button
A1e1 Bulb failure indicator lamp
A1e2 Door indicator lamp
A1e3 High beam indicator lamp
A1e4 Engine start/stop indicator lamp
A1e6 Seat belt warning lamp
A1e7 Alternator warning lamp
A1e8 Brake wear indicator lamp
A1e9 Parking brake indicator lamp
A1e10 Left tern signal indicator lamp
A1e11 Parking brake indicator lamp
A1e12 Low beam indicator lamp
A1e13 Preglow indicator lamp
A1e14 ESP indicator lamp
A1e15 Traction warning indicator lamp
A1e16 ABS indicator lamp
A1e17 EOBD indicator lamp
A1e18 Oil level indicator lamp
A1e19 Brake fluid level warning lamp
A1e20 Right turn signal indicator lamp
A1e21 Brake fluid level warning lamp
A1e22 SRS warning lamp
A1e23 Coolant temperature warning lamp
A1e24 Coolant level indicator lamp
A1e25 Dirty fuel filter indicator lamp
A1e26 Water in fuel filter indicator lamp
A1e27 Dirty air filter indicator lamp
A1e28 Washer fluid level indicator lamp
A1e29 RDK indicator lamp
A1e30 Fuel reserve/tank cap indicator lamp
A1e32 ADR indicator lamp
A1e33 Tachograph indicator lamp
A1e36 BAS indicator lamp
A1e37 LOW RANGE indicator lamp
A1e39 Diesel particulate filter indicator lamp
A1p1 Display
A1p2 Fuel level and reserve indicator
A1p5 Tachometer
A1p8 Speedometer
A1s2 Reset button
A1s3 Plus button
A1s4 Minus button
Operation of display in instrument cluster (A1)
The display in the instrument cluster is operated using the following buttons:
- M button
- Reset button
- Plus button
- Minus button
The functions are selected using the M button and the reset button. The values for the functions are set using the plus button and the minus button.
After the settings have been made, it is possible to return to the standard display in one of the following two ways:
- Press and hold down the M button for longer than 1 second
- Do not press any button for at least 10 seconds
Main menus
The following menu can be selected by pressing the M button:
- Query service date (active service system)
- Inspect engine oil level
- Set stationary heater
- Tire pressure monitor
- Set time
- Set date
Systems which are not installed in the vehicle are not shown in the display.
Switching from outside temperature indicator to digital speedometer
The outside temperature indicator can be switched to a digital speedometer by pressing the M button (hold down for longer than 1 second). To switch from the digital speedometer back to the outside temperature indicator, press the M button again (hold down for longer than 1 second).