GF00.20-P-2010GZ Display Service Scope, Function

GF00.20-P-2010GZ Display Service Scope, Function

The service code is shown in the multifunction display (A1p13). This includes the time taken to perform the service and is classified from A to H. The code is in ascending order. The codes are:
- Code A: Service scope of up to 1 h,
- Code B: Service scope of up to 2 h,
- Code H: Service scope of up to 8 h.

The evaluation of all the important data takes place in the central gateway control unit (N93) via the Service processor module.

The service scope can be determined in 3 different ways:
- The instrument cluster (A1) can be used to read out the workshop code
e.g. "4G3P", and this can be entered into the Workshop Information System (WIS). WIS breaks down this workshop code, determines the service scope and the additional operations to be performed for the vehicle. These are then preselected in the WIS. Then the vehicle-related service sheet can be printed out.
- The workshop code can be read out and noted via the instrument cluster. The stored service items can be used to look these up in the service booklet and then they can be allocated.
- The service operation can use STAR DIAGNOSIS to access the data from ASSYST PLUS. ASSYST PLUS is switched to the diagnosis state for this purpose.

Essentially, the following actions are possible:
- Display of all work to be performed for this service: A list is compiled of all the operations to be performed during this service date.
- Configuration of maintenance item: The maintenance items can be configured, by activating or deactivating them. Here, the corresponding weighting of all the other data for the item, e.g. maintenance intervals, exceeding limit, weighting) must be assigned with plausible values in the maintenance item by STAR DIAGNOSIS.
- Confirmation of services performed: An identifier is flagged for the corresponding maintenance items indicating that this service has been performed.
- Revocation of an erroneous confirmation of maintenance items: It is possible to reset a maintenance item (maintenance confirmed) once within a service period.
- Service memory read out: this provides information on maintenance already performed.
- If the central gateway control unit is to be replaced, all the relevant data are backed up by STAR DIAGNOSIS and transferred to the new central gateway control unit.