Front Suspension - Stabilizer Removal/Installation

FRONT STABILIZER REMOVAL/INSTALLATION [MZR 2.3 DISI Turbo]

1. Remove the joint cover. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

2. Disconnect the steering shaft from the steering gear and linkage. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

3. Remove the front crossmember component. Service and Repair

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

6. Inspect the wheel alignment and adjust it if necessary. Front Wheel Alignment









Front Stabilizer, Front Stabilizer Bushing and Front Stabilizer Bracket Installation Note

CAUTION:
- Verify that the front stabilizer bushings are not caught between the front stabilizer bracket and the front crossmember, and install the front stabilizer bracket using the following procedure.

1. Temporarily tighten bolts A and B shown in the figure.

2. Tighten bolt A.

3. Tighten bolt B.

4. Tighten bolt A.