Brake Hose (Rear) Removal/Installation

BRAKE HOSE (REAR) REMOVAL/INSTALLATION [MZR 2.5, MZR 2.3 DISI Turbo]

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. Add brake fluid, bleed the brakes, and inspect for leakage after the installation has been completed. Service and Repair









Clip and Brake Pipe Installation Note

1. Install the brake hose to the vehicle-side bracket and secure it using a clip.

2. Verify that the brake hose is not twisted.

3. Tighten the brake pipe to the specified torque using a commercially available flare nut wrench.