Selector Shaft: Service and Repair

SHIFT CONTROL MODULE REMOVAL/INSTALLATION [C66M-R]

Removal

1. Shift the shift lever to the neutral position.

2. Remove the plug hole plate. Plug Hole Plate Removal/Installation

3. Disconnect the negative battery cable. Removal and Replacement

4. Remove the air cleaner and air hose as a single unit. Service and Repair

5. Remove the battery and battery tray. Removal and Replacement

6. Disconnect the control cable from the transaxle.
a. Pull the lock pin in the direction of the arrow shown in the figure and release the control cable end lock.






b. Press the tabs on the control cable and disconnect the control cable from the bracket on the transaxle.






7. Remove the neutral switch in the order shown in the figure










8. Remove the detent ball pin in the order shown in the figure










9. Remove the back-up light switch in the order shown in the figure










10. Remove the shift control module in the order shown in the figure










Installation

1. Verify that the shift control module is in the neutral position.
NOTE:
- If the shift control module is in the neutral position, the shift lever with the weight can be moved up and down to a large extent.






2. Install the shift control module in the order shown in the figure










3. Install the back-up light switch in the order shown in the figure










4. Install the detent ball pin in the order shown in the figure










5. Install the neutral switch in the order shown in the figure










6. Connect the control cable to the transaxle.






7. Make sure that the shift lever can be shifted smoothly.

8. Install the battery tray and battery. Removal and Replacement

9. Install the air cleaner and air hose as a single unit. Service and Repair

10. Connect the negative battery cable. Removal and Replacement

11. Install the plug hole plate. Plug Hole Plate Removal/Installation