Seals and Gaskets: Service and Repair

OIL SEAL (DIFFERENTIAL) REPLACEMENT [C66M-R]

1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit. Aerodynamic Under Cover No. 2 Removal/Installation Splash Shield Removal/Installation

2. Drain the manual transaxle oil. Manual Transaxle Oil Replacement [C66M-R]

3. Disconnect the drive shaft (LH) from the MTX. Drive Shaft Removal/Installation

4. Disconnect the drive shaft (RH) from the joint shaft. Drive Shaft Removal/Installation

5. Remove the joint shaft. Joint Shaft Removal/Installation

6. Remove the oil seal (LH).






7. Remove the oil seal (RH).






8. Using the SSTs and a hammer, tap each a new oil seal (LH) in evenly until the SSTs contacts the transaxle case.






9. Using the SSTs and a hammer, tap each a new oil seal (RH) in evenly until the SSTs contacts the transaxle case.






10. Coat the lip of each oil seal with transaxle oil.

11. Install in the reverse order of removal.

12. Add the specified amount of specified transaxle oil. Manual Transaxle Oil Replacement [C66M-R]