Air Fuel Ratio (A/F) Sensor Removal/Installation

AIR FUEL RATIO (A/F) SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0]

WARNING:
- A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system.

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable. Removal and Replacement

3. Disconnect the A/F sensor connector.

4. Remove the wiring harness from the wire clip. (See Assembly of Wiring Harness to Wire Clip Note.)






5. Remove the A/F sensor using the SST.






6. Install in the reverse order of removal.

Assembly of Wiring Harness to Wire Clip Note

1. Assemble the wiring harness to the wire clip.
NOTE:
- Secure the wiring harness to the wire clip so that the band on the wiring harness is positioned to the right side of the wire clip.