Drive Belt Tensioner: Testing and Inspection

DRIVE BELT AUTO TENSIONER INSPECTION [SKYACTIV-G 2.0]

WARNING:
- A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing.

CAUTION:
- If the rubber part of the drive belt auto tensioner is damaged by a screwdriver or other tool, oil in the hydraulic pressure unit could leak and the tensioner may not operate normally. Be careful not to damage the rubber part of the drive belt auto tensioner.





1. Remove the generator drive belt. Service and Repair

CAUTION:
- To prevent damage to the drive belt auto tensioner, do not apply excessive torque after the tensioner moves full-stroke.

2. Insert the wrench into the cast hexagon on the drive belt auto tensioner, slowly turn it in the direction of the arrow shown in the figure, and fully depress.






NOTE:
- The drive belt auto tensioner is operated in the direction of the arrow by turning the wrench.






3. Verify that the drive belt auto tensioner moves smoothly in the operational direction.

- If it does not move smoothly, replace the drive belt auto tensioner. Removal and Replacement

4. Turn the drive belt auto tensioner pulley by hand and verify that it rotates smoothly.






- If it does not move smoothly, replace the drive belt auto tensioner. Removal and Replacement

5. Install the generator drive belt. Service and Repair