Variable Induction Position Sensor: Testing and Inspection

VARIABLE TUMBLE SHUTTER VALVE SWITCH INSPECTION [MZR 2.0, MZR 2.5]

Voltage Inspection

NOTE:
- The variable tumble shutter valve switch cannot be removed as a single unit. When replacing the variable tumble shutter valve switch, replace it together with the intake manifold as a single unit.

1. Connect the M-MDS to the DLC-2.






2. Switch the ignition to ON.

3. Verify that the variable tumble shutter valve switch output voltage (PID: IMRC_POS) is within the specification. On-Board Diagnostic Test Component Tests and General Diagnostics

- If not as specified, replace the intake manifold. Service and Repair