Standard Deployment Control System

DTC B2856, B2886, B2887 [STANDARD DEPLOYMENT CONTROL SYSTEM]

System Malfunction Location





Detection Condition

WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

- The SAS control module detects an error of impact magnitude set in the sensor, which occurs due to installation mismatch of the crash zone sensor or side air bag sensors.

Possible Causes

- Crash zone sensor mis-installed with wrong sensor
- Driver-side side air bag sensor mis-installed with wrong sensor
- Passenger-side side air bag sensor mis-installed with wrong sensor
- SAS control module malfunction

Diagnostic Procedure