B110E

DTC B110E, B110F, B232B, B233B, B2856, B2886, B2887 [TWO-STEP DEPLOYMENT CONTROL SYSTEM]

System Malfunction Location





Detection Condition

WARNING:
- Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

- The SAS control module detects an error of impact magnitude set in the sensor, which occurs due to installation mismatch of the crash zone sensor, side air bag sensors or pressure sensors.

Possible Causes

- Crash zone sensor not installed correctly or wrong sensor installed
- Driver-side side air bag sensor No.1 not installed correctly or wrong sensor installed
- Passenger-side side air bag sensor No.1 not installed correctly or wrong sensor installed
- Driver-side side air bag sensor No.2 not installed correctly or wrong sensor installed
- Passenger-side side air bag sensor No.2 not installed correctly or wrong sensor installed
- Driver-side pressure sensor not installed correctly or wrong sensor installed
- Passenger-side pressure sensor not installed correctly or wrong sensor installed
- SAS control module malfunction

Diagnostic Procedure