Vacuum Brake Booster: Service and Repair

POWER BRAKE UNIT REMOVAL/INSTALLATION [L3 WITH TC]

CAUTION:
- Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.

1. Remove the battery and battery tray. Removal and Replacement

2. Remove the master cylinder. Service and Repair

3. Loosen the brake pipe flare nuts as shown in the figure.






4. Move the brake pipes as shown in the figure.






5. Disconnect the steering shaft from the steering gear and linkage. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

6. Remove in the order indicated in the table.

7. Install in the reverse order of removal.

8. After installation, inspect the brake pedal. Testing and Inspection