Antenna Feeder No.1 Removal/Installation

ANTENNA FEEDER NO.1 REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front scuff plate Front Scuff Plate Removal/Installation

b. Front side trim Front Side Trim Removal/Installation

c. Upper panel Upper Panel Removal/Installation

d. Shift lever knob (MTX) Service and Repair

e. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation

f. Shift panel Shift Panel Removal/Installation

g. Side wall Side Wall Removal/Installation

h. Console Console Removal/Installation

i. Shift lever component (MTX) (See Service and Repair)

j. Selector lever component (ATX) Automatic Transaxle Shift Mechanism Removal/Installation

k. Glove compartment Service and Repair

l. Hood release lever Service and Repair

m. Lower panel Lower Panel Removal/Installation

n. Center panel Center Panel Removal/Installation

o. Audio unit Audio Unit Removal/Installation

p. Climate control unit Climate Control Unit Removal/Installation - Full-Auto Air Conditioner Climate Control Unit Removal/Installation - Manual Air Conditioner

q. A-pillar trim (RH) A-Pillar Trim Removal/Installation

r. Auto light/wiper control module (with auto light/wiper system) Auto Light/Wiper Control Module Removal/Installation

3. Partially peel back the hook.






4. Partially peel back the SIRIUS satellite radio antenna feeder.






5. Remove the clip A.

6. Peel off the tape.






7. Partially peel back the hook.

8. Remove the clips B.






9. Remove the antenna feeder No.1.

10. Install in the reverse order of removal.