With Scan Tool

Clearing DTCs Procedures Using SST (NGS tester)
1. After repairs have been made, perform the Diagnostic Trouble Codes (DTCs) reading procedure.





2. Press CLEAR.
3. Press the TRIGGER key.
4. Press the CANCEL key.
5. Ensure that the customer's concern has been resolved.

Note After repairing the ABS wheel-speed sensor or replacing ABS/TCS HU/CM (with TCS) or ABS HU/CM (without TCS), the ABS warning light may not go off when ignition key is turned ON. In this case, start engine and drive the vehicle at a speed of more than 10 km/h (6.2 mph) until the ABS warning light goes off.