Glove Compartment: Service and Repair

Glove Compartment

Removal and Installation

1. Remove the center instrument panel finish panel. For additional information, refer to Instrument Panel Finish Panel- Center Instrument Panel Finish Panel - Center.

2. Remove the 3 RH instrument panel finish panel screws.





3. Remove the RH instrument panel finish panel.

4. Remove the RH instrument panel side finish panel.
- Pull the instrument panel side trim finish outward to release the retaining clips.


5. Open the glove compartment.

6. Lower the glove compartment in the following sequence.
1. Lift upward and remove the 2 glove compartment stops.

2. Fully lower the glove compartment.


7. Remove the 3 glove compartment screws.





8. Remove the RH lower glove compartment screw.

9. Remove the glove compartment assembly.
- Pull the glove compartment assembly outward to release the retaining clips.
- Disconnect the electrical connectors.

10. To install, reverse the removal procedure.
- To install, make sure to align the retaining clips to the adjacent retaining clip holes.