FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Lincoln >> 2012 >> MKS AWD V6-3.5L Turbo >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Testing and Inspection >> Pinpoint Tests >> Automatic Transmission - 6F50/6F55 >> Pinpoint Test E: Transaxle Solenoid Power Control Circuit

Pinpoint Test E: Transaxle Solenoid Power Control Circuit




PINPOINT TEST E : TRANSAXLE SOLENOID POWER CONTROL CIRCUIT

NOTE: Refer to the Transaxle Vehicle Harness Connector illustration within the Transaxle Connector Layouts .

E1 CHECK FOR VOLTAGE AT THE TRANSAXLE VEHICLE HARNESS C168

- Disconnect: Transaxle Vehicle Harness C168.

- Use a mirror to inspect both ends of the connector for damage or pushed-out pins, corrosion, loose wires and missing or damaged seals.

- Ignition ON.

- Measure the voltage at the transaxle vehicle harness C168-15, circuit CET25 (BU/GN).





Is the voltage greater than 10 volts?

Yes
INSTALL a new solenoid body. REFER to Solenoid Body Assembly . RECONNECT all components. TEST the system for normal operation.

No
GO to E2 .

E2 CHECK THE TRANSAXLE SOLENOID POWER CONTROL CIRCUIT FOR AN OPEN

- Ignition OFF.

- For vehicles equipped with a 3.7L engine, disconnect the PCM transaxle C175T.

- For vehicles equipped with a 3.5L Gasoline Turbocharged Direct Injection (GTDI) engine, disconnect the PCM transaxle C1381T.

- For vehicles equipped with a 3.7L engine, measure the resistance between the PCM transaxle C175T-47, circuit CET25 (BU/GN) and transaxle vehicle harness C168-15, circuit CET25 (BU/GN).

-




- For vehicles equipped with a 3.5L GTDI (Gasoline Turbocharged Direct Injection) engine, measure the resistance between the PCM transaxle C1381T-50, circuit CET25 (BU/GN) and transaxle vehicle harness C168-15, circuit CET25 (BU/GN).

-




Is the resistance less than 5 ohms?

Yes
GO to E3.
No
REPAIR circuit CET25 (BU/GN) for an open. RECONNECT all components. TEST the system for normal operation.

E3 CHECK THE TRANSAXLE SOLENOID POWER CONTROL CIRCUIT FOR A SHORT TO GROUND

- Measure the resistance between the transaxle vehicle harness C168-15, circuit CET25 (BU/GN) and ground.

-




Is the resistance greater than 10,000 ohms?

Yes
INSTALL a new PCM. RECONNECT all components. TEST the system for normal operation.
No
REPAIR circuit CET49 (BN) for a short to ground. RECONNECT all components. TEST the system for normal operation.

pro multis Credits:Operation CHARM About Operation CHARM