Caliper Removal and Installation, Front

Brake Caliper

Material:

Removal and Installation

WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the brake caliper flow bolt and position the hose aside.
^ Discard the 2 copper washers.
^ To install, tighten to 25 Nm (18 ft. lbs.).
3. Remove the 2 brake caliper guide bolts.
^ To install, tighten to 27 Nm (20 ft. lbs.).
4. Remove the brake caliper.

5. NOTE: During installation, make sure that the brake caliper hose is not twisted.

To install, reverse the removal procedure.
^ Bleed the brake system.