Removal

1UR-FSE LUBRICATION: OIL LEVEL SENSOR (for 2WD): REMOVAL

1. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

2. REMOVE NO. 2 ENGINE UNDER COVER Removal

3. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER Removal

4. DRAIN ENGINE OIL Replacement

5. DISCONNECT OIL COOLER TUBE

(a) Remove the 2 bolts and 2 clamps to disconnect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube.





6. REMOVE CRANK POSITION SENSOR BRACKET

(a) Using a clip remover, disconnect the harness clamp.





(b) Remove the bolt and crank position sensor bracket.

7. REMOVE ENGINE OIL LEVEL SENSOR

(a) Disconnect the engine oil level sensor connector.





(b) Remove the 4 bolts.

(c) Rotate the engine oil level sensor 180° and remove it.





(d) Cut off the gasket as shown in the illustration.





(e) Remove the gasket from the oil level sensor.

HINT
After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.