Operation Check

INTERIOR: REAR DOOR SUNSHADE SYSTEM: OPERATION CHECK

HINT
Before performing the inspection, make sure the power window control system is operating normally.

1. CHECK MANUAL OPERATION

(a) By operating the switch, check that the rear curtain rises and lowers.

(b) When the rear curtain on both sides or one side is fully raised and the No. 2 console switch's rear door sunshade switch is pressed, check that the rear curtains lower. When the switch is pressed again, check that the rear curtains rise.

2. CHECK KEY OFF SWITCH OPERATION

(a) When the read door sunshade is operating and the engine switch is turned from on to off, check that the operation continues.

(b) After the engine switch is turned from on (IG) or start to off, check that the rear curtain can be operated for approximately 60 seconds.

3. CHECK WINDOW OPERATION LINKED FUNCTION

(a) After the rear curtain is fully raised or while the rear curtain is being raised, if the window is moved out of the fully closed position, check that the sunshade automatically lowers.

4. CHECK JAM PROTECTION FUNCTION (MECHANICAL DETACHMENT FUNCTION)

CAUTION:
* Do not use a part of your body, for example, your hand, to check the jam protection.
* Do not allow anything to become caught in the rear curtain by accident in this procedure.
* Perform the inspection from the inside of the vehicle.
NOTICE:
* Do not use hard objects such as a hammer, to avoid damage to the rear curtain.

(a) When the rear curtain close operation is operating and an object is caught between the vehicle body and rear curtain, check that the rear curtain detaches.

(b) After the rear curtain detaches, the position reset operation must be performed Rear Door Sunshade System.