Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

1. INSTALL REAR AIRBAG SENSOR LH

(a) Check that the engine switch is off.





(b) Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(c) Install the rear airbag sensor with the bolt.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.

(e) Connect the connector.

2. INSTALL REAR SEAT SIDE GARNISH LH Installation

3. INSTALL REAR DOOR SCUFF PLATE LH Installation

4. INSTALL REAR SEATBACK ASSEMBLY LH (for Fixed Seat Type) Installation

5. INSTALL REAR SEATBACK ASSEMBLY LH (for Ottoman) Installation

6. INSTALL REAR SEATBACK ASSEMBLY LH (for Power Seat) Installation

7. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) Installation

8. INSTALL REAR SEAT CUSHION ASSEMBLY LH (for Ottoman) Installation

9. INSTALL REAR SEAT CUSHION ASSEMBLY LH (for Power Seat) Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Pinout Values and Diagnostic Parameters.