Removal

POWER SOURCE / WIRING: BATTERY CURRENT SENSOR: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE ENGINE ROOM SIDE COVER RH Removal

4. REMOVE FRONT FENDER PROTECTOR UPPER RH Removal

5. REMOVE BATTERY CURRENT SENSOR

(a) Disconnect the connector from the battery current sensor assembly.

(b) Remove the bolt, ground terminal and battery current sensor assembly.