Repairs and Inspections Required After a Collision: Service and Repair

Repairs and Inspections Required After a Collision

1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT

(a) Perform zero point calibration and sensitivity check if any of the following conditions apply Initialization.

* The front seat set (occupant classification ECU) is replaced.

* The passenger airbag ON/OFF indicator indicates OFF when the front passenger seat is not occupied.

* The vehicle is brought to the workshop for repair due to an accident or a collision.

2. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT

(a) When the airbag has not deployed, confirm the DTCs by checking the SRS warning light. If there is any malfunction in the SRS airbag system, perform troubleshooting.

(b) When any of the airbags have deployed due to the collision, be sure to replace all sensors in the damaged areas and center airbag sensor assembly.