Canada - Interior - Front Memory Seat Initialization
BulletinL-TCI-3000
Issue Date
September 13, 2011
Title:
INITIALIZATION OF FRONT MEMORY SEAT ECU DURING PDS
Service Category
General
Section
Pre-Delivery Service
Market
Canada
APPLICABILITY:
INTRODUCTION:
As a result of the removal of the DCC fuses (No. 1 and No. 2), the driving position memory function of the driver's seat will be inoperative due to loss of the seat position memory stored in the seat ECU. Initialize the front memory seat ECU after installing the DCC fuses during Pre-Delivery Service (PDS).
WARRANTY INFORMATION:
DRIVER'S SEAT INITIALIZATION PROCEDURE:
1. Cycle the ENGINE START STOP ignition switch to the IG-ON position.
2. Operate the vertical height switch to the lower side 3 times.
3. Within 10 seconds, simultaneously operate the seatback angle switch to the rear side and the vertical height adjustment switch to the lower side until a beep is heard.
4. Operate the seat position control switch and slide the seat to the rearmost position.
NOTE
When operating the control switch, the warning buzzer sounds.
After operating the seat position control switch, the following operations will occur automatically:
- The head restraint automatically moves to the uppermost position and a beep is heard.
- The seat cushion length automatically slides to the rearmost position and a beep is heard.
HINT
The two seat operations described above occur simultaneously.
5. Move the seatback angle switch forward until a beep is heard.
6. Operate the head restraint height adjustment switch and check that the head restraint moves to the uppermost and lowermost positions normally. (Refer to "1" in figure 4.)
7. Operate the seat position control switch and check that the seat slides forward and rearward and that the beep is NOT heard. (Refer to "2" in figure 4.)
FRONT PASSENGER'S SEAT INITIALIZATION PROCEDURE:
1. Simultaneously operate the seatback angle switch angle switch to the rear side and the vertical height adjustment switch to the lower side until a beeping sound is heard.
2. Within 10 seconds, simultaneously operate the seatback angle switch to the rear side and the vertical height adjustment switch to the lower side until a beep is heard.
3. Operate the seat position control switch and slide the seat to the rearmost position.
NOTE
When operating the control switch, the warning buzzer sounds.
After operating the seat position control switch, the following operations will occur automatically:
- The head restraint automatically moves to the lowermost position and a beep is heard.
- The seat vertical height automatically moves to the uppermost or lowermost position and a beep is heard.
HINT
The two seat operations described above occur simultaneously.