Removal

ENGINE HOOD / DOOR: LUGGAGE COMPARTMENT DOOR CLOSER ASSEMBLY: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

(a) Using a screwdriver, detach the 3 claws.





HINT
Tape the screwdriver tip before use.

(b) Remove the 2 screws and assist grip.





4. REMOVE DOOR INSIDE HANDLE BEZEL

(a) Using a screwdriver, detach the 4 claws and remove the bezel.





HINT
Tape the screwdriver tip before use.

5. REMOVE SWITCH BEZEL (w/ Power Trunk Lid System)

(a) Using a screwdriver, detach the 2 claws and remove the bezel.





HINT
Tape the screwdriver tip before use.

6. REMOVE NO. 2 COURTESY LIGHT ASSEMBLY

(a) Using a screwdriver, detach the 2 claws and remove the courtesy light.





HINT
Tape the screwdriver tip before use.

(b) Disconnect the connector.

7. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH

(a) Detach the 2 claws and remove the rear combination light service cover LH.

8. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH

(a) Detach the 2 claws and remove the rear combination light service cover RH.

9. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH

(a) Using a clip remover, remove the 3 clips and cover.





10. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

(a) Using a clip remover, remove the 3 clips and cover.





11. REMOVE BACK DOOR TRIM COVER

(a) Using a clip remover, remove the 4 clips.





(b) Remove the 10 clips and cover.

12. REMOVE LUGGAGE DOOR LOCK OPENER ASSEMBLY

(a) Remove the screw and door lock opener.





13. REMOVE LUGGAGE DOOR CLOSER ASSEMBLY

(a) Disconnect the connector.





(b) Remove the 3 bolts and luggage door closer.