Initialization

ENGINE HOOD / DOOR: POWER TRUNK LID SYSTEM: INITIALIZATION

1. RESET METHOD

NOTICE:
Perform initialization of the power trunk lid system (power trunk lid control ECU initialization) if one of the following is performed: 1) The negative (-) battery cable is disconnected; 2) a wire harness, the luggage closer motor (power trunk lid control ECU) or luggage compartment door closer is replaced or removed/installed; or 3) the RR MPX-B1 fuse is replaced or removed/installed. If initialization is not performed, the power trunk lid system will not operate.

(a) Completely close the luggage compartment door by hand once.

HINT
It is not necessary to perform initialization if the negative (-) battery cable is disconnected while the luggage compartment door is closed.

2. CHECK POWER TRUNK LID FUNCTION

HINT
* Proceed to Operation Check Operation Check.
* If the power trunk lid system does not operate and/or the luggage compartment door does not open, disconnect the negative (-) battery cable. Then wait 10 seconds, reconnect the cable and perform initialization of the power trunk lid system again.