Removal

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL

2. DISCONNECT FRONT SPEED SENSOR WIRE Removal

3. SEPARATE FRONT DISC BRAKE CYLINDER ASSEMBLY Removal

4. REMOVE FRONT DISC Removal

5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY Removal

6. REMOVE STEERING KNUCKLE

(a) Remove the clip and loosen the nut.

(b) Remove the 2 bolts and steering knuckle from the lower ball joint.

SST : 09960-20010

09961-02060

(d) Using SST, remove the steering knuckle from the upper suspension arm as shown in the illustration.

SST : 09960-20010

09961-02010

09961-02060

CAUTION:
Apply grease to the end and threads of the SST bolt.

NOTICE:
* Install SST so that A and B are parallel.
* Be sure to place a wrench on the part indicated in the illustration.
* Make sure that SST is securely positioned on the steering knuckle spacer.
* Be careful not to damage the steering knuckle because it is made of aluminum and may be damaged easily.
* Do not damage the ball joint dust cover.
* Make sure that the SST string is securely tied to the vehicle.

HINT
Apply protective tape to the steering knuckle.

If the steering knuckle spacer has come off, replace the steering knuckle with a new one.